Tools Required; Hardware Kit - Grunkel SP-18 AT-2 Manual De Instrucciones

Tools required

Phillips Head Screw Driver
Ratchet or Driver with 13 mm (1/2") Socket
Electric or Portable Drill
6 mm (1/4") Drill Bit and Stud Finder for Drywall Installation
10 mm (3/8") Masonry Bit for Concrete Installation
Level

Hardware kit

(A) M8 x 63 Lag Bolt (x5)
(B) M9.5 x 22 x 2.5 Washer (x5)
(C) Concrete Anchor (x5)
(D) M6 x 12 Screw (x8)
(E) M8 x 12 Screw (x4)
Instalación
Part 1B – Mounting to the Wall (Concrete)
IMPORTANT! For safety reasons, the concrete wall must be capable of supporting the
combined weight of the mount and the display. The manufacturer takes no responsibi-
lity for failure caused by walls of insufficient strength.
Place the mount against the wall in the desired location. Make sure it is level. While ano-
ther person holds the mount in place, mark five locations as shown in the illustration for
securing the mount to the wall (see Fig. 3).
Set the mount aside and drill a 10 mm (3/8") hole at each marked location. Remove any
excess dust from the holes.
Insert a concrete anchor (C) into each hole so that it is flush with the concrete surface
(see Fig. 4). A hammer can be used to lightly tap the anchors into place if necessary.
NOTE: If the concrete wall is covered by a layer of plaster or drywall, the concrete an-
chor must pass completely through the layer to rest flush with the concrete surface.
Place the mount back against the wall and attach it using the lag bolts (A) and M9.5 x
22 x 2.5 washers (B) provided (see Fig. 5). Do not over-tighten these bolts and do not
release the mount until all bolts are in place. Ensure that the mount remains level after
all bolts are secured.
(F) M6 x 18 x 1.5 Washer (x4)
(G) M8 x 19 x 1.5 Washer (x4)
(H) M6 x 16 x 1.0 Washer (x4)
(I) S10 Socket Wrench (x1)
12