Nevir NVR-4372 CNF Manual De Instrucciones página 42

Problem
Appliance
dose not work
The food is too
warm.
Appliance
cools too
much
Unusual noises
Water on the
floor
If the malfunction shows again, contact the Service Center.
Possible cause
Temperature regulation
knob is set at number "0".
Mains plug is not
plugged in or is loose
Fuse has blown or is
defective
Socket is defective
Temperature is not
properly adjusted.
Door was open for an
extended period.
A large quantity of warm
food was placed in the
appliance within the last
24 hours.
The appliance is near a
heat source.
Temperature is set too cold.
Appliance is not level.
The appliance is touching
the wall or other objects.
A component, e.g. a
pipe, on the rear of the
appliance is touching
another part of the
appliance or the wall.
Water drain hole is blocked.
Solution
Set the knob at other number to
switch on the appliance.
Insert mains plug.
Check fuse, replace if necessary.
Mains malfunctions are to be
corrected by an electrician.
Please look in the initial Temperature
Setting section.
Open the door only as long as
necessary.
Turn the temperature regulation to
a colder setting temporarily.
Please look in the installation
location section.
Turn the temperature regulation knob
to a warmer setting temporarily.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
See the Cleaning and Care section.
42