Ega Master 57074 Manual De Instrucciones página 11

in figure A. Pneumatic tools operate on a wide range of air pressures. For maximum efficiency and
longer tool life, the pressure of the air supplied to these tools should not exceed the rated PSI at the
tool when the tool is running.
Using a higher than rated pressure will cause faster wear and drastically shorten the tool's life.
A higher air pressure can also cause an unsafe condition. The inside diameter of the hose should
be increased to compensate for unusually long air hoses (over 25 feet). Minimum hose diameter
should be 3/8" I.D. and fittings should have the same inside dimensions. The use of air line
lubricators and air line filters is recommended to prevent water in the line that can damage the tool.
Drain the air tank daily. Clean the air inlet filter screen on at least a weekly schedule to remove
accumulated dirt or other matter that can restrict air flow.
11