Switching On The Appliance - Nevir NVR-4422 CSD Manual De Instrucciones

essential to ensure that refrigerant tubes are not damaged during
transportation and the installation of the appliance. In the event that
the refrigerant circuit is damaged, avoid naked flames or sources of
ignition and ventilate the room in which the appliance is situated.

Do not damage the refrigerant circuit.

Do not allow children to play with the appliance. Children must never
play in or around the appliance.

If using an adaptor, this must be used in accordance with the
manufacturer's instructions and ensure that the electrical circuit is not
overloaded as this could cause overheating.

Do not twist or bend the cables, and keep them away from hot
surfaces.

Do not plug in or unplug this appliance with wet hands.

Following installation make sure that the power cable is not trapped
underneath the appliance.

If the power supply cord is damaged, it must be replaced by the
manufacturer, it's service agent or similarly qualified persons in order
to avoid a hazard.
Section 3. Operating the Appliance

3.1. Switching on the Appliance


Allow the appliance to stand for a minimum of 4 hours after installation.

Plug in the appliance and switch on at the mains supply.

Set the thermostat control to the required setting as detailed in the
Temperature Control section (3.2.).
17
English