Publicidad
Idiomas disponibles
Idiomas disponibles
Trooble shooting
Problem
Buttons
+
flashing
+ led
lighted
After closing the appliance with food between
plates, the appliance turns itself to manual
mode with flashing
+
+
+ discontinue beep
then after few seconds, it heats in
manual mode under
525°F/ 270°C
The appliance stops during the cycle of
preheating or cooking.
The 6 indicator lights flashing
+ one of the
button flashing
+ discontinue beep
The appliance no longer beeps
After the preheating , I have put my food on
the grill but cooking cycle does not start.
The indicator stays on
and
button flashing
The 6 indicator lights flashing
+ one of the
+ discontinue or continue beep
Tip, especially for meat: the cooking results on the preset programs may vary depending on origin, cut and quality of
the food being cooked, the programs have been set and tested for good quality food.
Similarly, the thickness of the meat has to be taken into account during cooking; you cannot cook food that is thicker
than 1 1/2 inches.
16
Cause
Preheating not respected.
Switching "ON" of the appliance or starting
an automatic cooking cycle with food
between plates. The manual mode is
automatically activated.
Preheating time not completely done. Grill
has been opened and food inserted on plate
before end of preheating.
The appliance has been kept open for too
long while cooking.
The appliance has been idle too long after
the end of preheating or keep warm.
Appliance failure.
Your food is thicker than 1,5 inches.
You have not completely opened the grill to
place the food.
Not sensing the food. The food thickness
too thin, "OK" is flashing.
Appliance failure :
Appliance stored or used in a room that is
buttons flashing
too cold.
Appliance over heating.
Solution
• 2 possible options:
- choose the temperature setting by pressing the
button
and then press OK. Allow to cook,
but you must monitor the cooking (manual mode).
Temperature can be adjusted by
- Open the appliance, remove the food,
close the appliance properly, select a cooking
program and press OK. Wait until end of
preheating (Preheating indicator light fixed).
Allow to cook, but you must monitor the cooking
because it is in manual mode. Temperature can be
adjusted by
button.
or
Open the appliance, remove the food, close the
appliance properly, and wait until end of
preheating (Preheating indicator light fixed).
Unplug the appliance and wait few minutes.
Plug again your appliance and switch ON.
Unplug the product and contact your customer
service.
1 1/2 inches
Food must not be thicker than
Completely open the grill then close it.
Confirm the start of the cooking by pressing
the
button.
Unplug the appliance and wait few minutes.
Plug your appliance in again and switch ON.
If the problem persists, contact your Customer
service.
button.
.
Publicidad
Capítulos
