Craftsman 580.752722 Instrucciones De Uso página 13

For maximum rinsing (higher pressure and
lower flow), for stubborn or hard to reach
surface such as second story surfaces, paint
removal, oil stains, rust removal or other
stubborn substances (tar, gum, grease, wax,
etc.), select red max ProjectPro
TM
nozzle.
4. Pull back on collar, insert selected ProjectPro
TM
nozzle and release collar. Tug on ProjectPro
TM
nozzle to make sure it is securely in place.
5. For most effective cleaning, keep ProjectPro
TM
nozzle from 8 to 24 inches away from cleaning
surface. If you get the nozzle too close, you may
damage the cleaning surface.
6. DO NOT get closer than 6 inches when cleaning tires.
How to Use the HydroFoam
TM
Launcher
The quick-connect on the nozzle extension allows you
to attach the HydroFoam
TM
launcher. Use the
HydroFoam
TM
launcher to apply HydroFoam
TM
wash
or other project specific cleaners to help break down
stubborn dirt and grime on a variety of surfaces.
Follow these instructions to attach the HydroFoam
TM
launcher:
1. Engage trigger lock on spray gun.
2. Pull back collar on quick-connect and pull current
ProjectPro
TM
nozzle off. Store ProjectPro
TM
nozzles in holder provided on the accessory tray.
3. Pull back on collar, insert HyrdoFoam
TM
launcher
and release collar. Tug on HyrdoFoam
TM
launcher
to make sure it is securely in place.
IMPORTANT: Also see the HydroFoam
TM
launcher
and wash instruction sheet for important instructions
and uses.
Cleaning and Applying Detergent
IMPORTANT: Use detergents designed specifically
for pressure washers. Household detergents could
damage the pump.
CAUTION
Starting the engine without all the hoses connected and
without the water turned ON will damage the pump.
Damage to equipment resulting from failure to follow this
instruction will void warranty.
To apply detergent follow these steps:
1. Review ProjectPro
TM
nozzle and HydroFoam
TM
launcher use.
2. Prepare HydroFoam
TM
wash or detergents as
required by manufacturer.
3. Pour solution into cleaning tank labeled A or B.
NOTE: Each cleaning tank holds two quarts.
4. Fill other cleaning tank with a different prepared
solution, as desired.
5. Make sure HyrdoFoam
TM
launcher is installed.
NOTE: Detergent cannot be applied with the high
pressure nozzles (Yellow, Orange or Red).
6. Make sure garden hose is connected to water inlet
and water supply is turned on. Check that high
pressure hose is connected to spray gun and
pump; start engine.
7. Rotate detergent shut-off valve on desired
cleaning tank to "On" position.
L_ "Off" Position
L Only one detergent solution should be used at a time to
avoid possible bodily injury and/or property damage.
8. Apply HydroFoam
TM
wash or detergent solution to
a dry surface, starting at lower portion of area to be
washed and work upward, using long, even,
overlapping strokes.
NOTE: To prevent water spotting on vehicles, work in
a shaded area and allow surfaces to cool before
beginning.
13