Placing The Device In Operation; Switching On/Off; Volume; Main Menu - Adayo HM4Z05A Manual De Instrucciones

Placing the device in operation

Switching on/off

Switching on/off with the
For switch-on, press the
For switch-off, hold the
than 2 seconds.
Switching on/off via vehicle ignition
If the car sound system is connected with the vehicle
ignition and it was switched off with the
switched on or off with the ignition.

Volume

Adjusting the volume
You can adjust the volume in steps from 0 (off) to 39
(maximum).
Press the / button and drag left/right on the
volume bar to change the volume.
Muting the car sound system (Mute)
Briefly press the button to mute the device or to
reactivate the previous volume.
button
button.
button pressed for more
button, it is

Main menu

In the main menu, you press the buttons on the touch-
screen to call up the different sources and operating
modes.
Press the [ ] button.
- Or -
In the current source, press the top left corner.
The main menu is displayed.
As long as you do not select a new audio source, the
last active audio source is played back.
Note:
The figures used in these instructions are intended
to facilitate the explanations and details may deviate
from your device.

Setting the reception area

This car sound system is designed for operation in
different regions with different frequency ranges and
station technologies. The factory default of the reception
area is "USA1 (FM/AM)". You can set a different reception
area.
In the main menu, press the [
The Setting menu is displayed.
In the left area of the Setting menu, press the
[ General ] button.
The current setting is displayed behind "Radio Area".
Tap on the [ Radio Area ] button to display the list of
available reception areas.
Select the desired reception area.
The list is hidden, the selected reception area is set.
Press the [ ] button.
The main menu is displayed again.
Startup
] button.
5