Setting The Clock - Mr Coffee MP Serie Manual De Instrucciones

I : R
MPORTANT ESETTING
The programmable timer will not automatically brew the next day if left in the AUTO
position after its last use. This is a safety feature. If the OFF indicator light in the lower
right hand corner of the clock display is illuminated, reset AUTO BREW by turning the
control switch to OFF, then to AUTO.
PM
12:00
N : You do not have to set your clock before the Coffeemaker will operate. Plug in
OTE
the power cord, press SELECT once to turn the Coffeemaker on. The ON light
will illuminate and the clock will stop flashing, but it will not keep time.
1. Plug the power cord into your electrical outlet. The clock display will flash
until you set the time.
2. Alternately press and hold the HOUR and MINUTE buttons until you reach the current
time.
3. The PM indicator light in the display will illuminate to indicate PM time.
1. You must first set the clock to the correct time before setting the Auto brew.
2. Press the PRESS/HOLD button, then alternately press the HOUR and MINUTE buttons
to set the time you want the Coffeemaker to start brewing. The Auto indicator light
will flash during this time.
3. Press the PRESS/HOLD button again to turn off the flashing light. If the Auto light
is not flashing, pressing the HOUR or MINUTE buttons will change the clock time.
B
1. Follow Steps 1 – 5 in the BREWING Section.
2. Press the PRESS/HOLD button. The AUTO indicator light should illuminate.
3. Brewing will begin at the preset time. The coffee will remain hot in the decanter for
2 hours. To keep your coffee hot for an additional 2 hours, press the SELECT button.
The ON indicator light should illuminate.
A B
UTO
(Models MPX20, MPX23 Only)
Hour Min. Auto Select
S
ETTING
(MPX30, MPX33, CBMPX30)
S
ETTING THE
P
RESETTING THE
A
REWING UTOMATICALLY AT THE
P
REW AT THE RE
C T
LOCK AND IMER
C
LOCK
B T
REWING
P
7
-S T
ET IME
Auto Start
On
1 – 4 Cup
–
Clean
WARMER TEMP
IME
T
RESET IME
+