DeLOCK 89379 Manual Del Usuario página 3

English
Driver Installation
Note:
Perform the driver installation before the hardware installation.
1. Switch on your computer.
2. Put the driver CD in the CD ROM drive.
3.
Open Windows Explorer, select: CD-drive\Marvell\MSUSetup.exe.
4.
Follow the installation instruction and confirm the license terms.
5. The driver will now be installed.
6. After the driver installation please follow the hardware installation.
Hardware Installation
1.
First, install the M.2 SSD onto the PCI Express card.
2. Turn off your PC and unplug the power cord.
3. Open the housing.
4. Remove the slot holder from the available PCI Express slot.
5. Insert the card straight and carefully into the free PCI Express slot, until it is
well seated.
6.
Use a screw to attach the card to the housing.
7. Connect your HDDs or SSDs to the SATA 7 pin ports on the PCI Express
card, therefor use your existing SATA cables.
8. Reattach the housing and connect the power cord to the AC adapter.
Installation
1.
When the installation of the device is finished, the Hybrid card will be
automatically installed after you restart the computer.
2. You can now start to use the device.
Marvell BIOS Utility (MBU) for RAID / HyperDuo Setup
Warning: All data on the memory associated with article 89379 will be erased
irretrievably.
To create a RAID/HyperDuo virtual disk:
Skip this section if you are not going to create a RAID/HyperDuo virtual disk.
1.
Start your Computer.
2.
Press the [Ctrl] + [M] key on the keyboard at the same time to enter the
Marvell BIOS Utility (MBU).
3. Once the MBU is entered, scroll to HBA0: Marvell 0 in the Topology pane by
the up and arrow key on the keyboard and press Enter.
-3-