External Equipment; Using The Auxiliary Input - Panasonic SC-UA7 Instrucciones De Funcionamiento

Note:
•
The play timer starts at a low volume and increases
gradually to the preset level.
•
The record timer starts 30 seconds before the set time with
the volume muted.
•
The timer comes on at the set time every day if the timer is
on.
•
If you switch off the system and then switch on again while
a timer is in operation, the timer will not stop at the end
time.

External equipment

Preparation
• Disconnect the AC mains lead.
• Switch off all equipment and read the appropriate
operating instructions.
Note:
•
Do not bend cables at sharp angles.
•
Components and cables are sold separately.
Using the optical input
You can connect a TV, VCR, DVD player etc., and listen
to the audio through this system.
Rear panel
of this unit
Optical digital audio cable
(not supplied)
1
Connect the external equipment.
2
Press [RADIO/EXT-IN] to select "D-IN".
3
Play the external equipment.
Note:
•
This system can only detect linear PCM signals.
•
Sampling frequency: 32 kHz, 44.1 kHz and 48 kHz
•
The sound is muted if the signal format or frequency is not
supported.
•
If there are sounds coming from the TV's speakers,
decrease the volume of the TV to its minimum.
•
Read the operating instructions of the external equipment
for details.
•
If you want to connect equipment other than those
described, refer to the audio dealer.
•
Sound distortion can occur when you use an adaptor.
TV (not supplied)

Using the auxiliary input

You can connect a VCR, DVD player etc., and listen to
the audio through this system.
Rear panel
of this unit
Audio cable
(not supplied)
1
Connect the external equipment.
2
Press [RADIO/EXT-IN] to select "AUX 1".
3
Play the external equipment.
Note:
•
If you want to connect equipment other than those
described, refer to the audio dealer.
•
Sound distortion can occur when you use an adaptor.
Connecting a portable audio equipment
You can play music from a portable audio equipment.
Preparation
• Switch off the equaliser (if any) of the portable audio
equipment to prevent sound distortion.
• Decrease the volume of the system and the portable
audio equipment before you connect or disconnect the
portable audio equipment.
Portable audio equipment
(not supplied)
1
Connect the portable audio equipment.
Plug type: Ø 3.5 mm stereo
2
Press [RADIO/EXT-IN] to select "AUX 2".
3
Play the portable audio equipment.
DVD player (not supplied)
Audio cable
(not supplied)
15
15