Hayward ZRD Serie Manual De Instalación página 12

Potential Redox Calibration Menu (O.R.P.)
Pressing the CAL key for 3 seconds takes you into the calibration menu. If calibration was excluded during
programming, the following appears on the display:
Calibration
Off
If calibration is active:
Cal
Calibration
Automatic
It is possible to select automatic or manual mode.
- Automatic calibration:
The buffer solution value appears on the display. Insert the probe in the bottle and press the
countdown necessary to complete calibration will appear on the display. If the alignment quality is below 50%, an
error message appears on the display and you should press
after 4 seconds). If the quality is above 50%, the value is shown on the display and you should press the
to complete the procedure.
- Manual calibration:
The buffer solution value appears on the display. Insert the probe in the bottle and press the
465 mV should now flash on the display. Insert the probe in your solution and use the
value of the solution in your possession, then confirm by pressing the
as before
Hayward Flow Control
Calibration
Automatic
-­‐
Calibration
Manual
www.haywardflowcontrol.com
Automatic Cal.
Buffer Sol. 465mV
Quality
||||||
-­‐
Automatic Cal.
+
Buffer Sol. 465mV
to exit calibration (the pump exits automatically
key and begin the calibration procedure
Wait.... 60s
Buffer Sol. 465mV
100% Automatic Cal.
ok 465mV Error 465mV
Wait.... 60s
Buffer Sol. 600mV
Quality 100% Automatic Cal.
|||||| ok 600mV Error
key. A 60 second
key. The value of
keys to display the
1-888-INDL (1-888-429-4635)
600mV
key
ZRDIOM
Pg. 10 of 11