Panacom SP-3092 Manual Del Usuario página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PANEL/REAR PLATE/MP3 FUNCTION AND OPERATION
Volume: it is used to adjust the sound of volume.
TREBLE (treble): it is used to adjust the gain of music treble. Bass: it is used to adjust the gain of music bass.
EQ (equilibrium): it is used to adjust music frequency curve and gain and attenuation within certain frequency.
MIC. VOL (microphone volume): it is used to adjust the volume of microphone
MIC. TREBLE (microphone treble): it is used to adjust the gain of microphone treble.
MIC. BASS (microphone bass): it is used to adjust the gain of microphone bass.
ECHO (microphone echo): it is used to adjust the echo depth of microphone.
DELAY (microphone delay): it is used to adjust the effect of microphone echo delay.
MIC1 MlC2 (microphone 1 and microphone 2): they are used to connect the plug interface of the wire microphone.
GT 1, GT2 (guitar 1 and guitar 2): they are used to connect the interface of guitar audio wire.
GUITAR. VOLUME (guitar volume): it is used to adjust the volume after the guitar input function is amplified.
DC FUSE (DC fuse): it is used for the power to supply the fuse of the whole machine with the protective tube of
F10A/250V.
POWER (power switch): the switch break-make power is applicable to the power control of sound amplifier of
thewhole machine instead of that of charging power. When the adapter is connected, the battery charging is not
controlled by the switch.
DC15V IN (15V DC power input): the interface of external power adaptor; please use the original adapter.
CHARGING (indicator lamp of battery power): after the power adaptor is connected, the indicator lamp will be on and
battery starts to be charged
FULL (indicator lamp of full charge): when adapter is used to charge the battery, it means full charge when the indicator
lamp is on.
WIRELESS MIC ANT (built-in microphone antenna): when you use wireless microphone, please make the antenna
vertically upward, so as to reach a better receiving effect.
12V BATTERY IN (external 12V battery interface): please carefully check the anode and cathode when connecting and
the applied connection line can not be smaller than 0.75 square meters. Attention shall also be paid to the firmness
when connecting it.
LINE IN (external audio interface): it is used to connect the compatible audio equipment such as DVC and computer.
Display screen of MP3 encoding player: it is used to display the playing track, playing time or the receiving rate under
receiving status.
USD interface (U disk interface): when MP3 function of U disk is needed, insert the U disk with MP3 songs to the
interface.
EQ: Equalize your music
SD/MMC CARD (interface of SD card and MMC card): insert SD card or MCC card with copied MP3 songs to the
interface.
Key: pressing the key to switch pause status under playing status or vice versa.
Stop key: pressing the key to stop playing under playing status; you are suggested to stop the key and
change U disk when you want to change U disk.
MP3/LINE-MODE (audio input switch): it is used to switch to use the external audio or built-in MP3 encoding
sound as the signal source of audio amplifier.
VOL-key: select the previous song for playing: the volume will be reduced by pressing the key for longer
than 3seconds.
VOL+ key: select the next song for playing: the volume will be increased by pressing the key for longer
than 3 seconds.
REPEAT (repetitive playing): press the key for repeating of single song or total songs.
Pg. 5

Publicidad

Tabla de contenido
loading

Tabla de contenido