Auto Power Off Function - Audio-Technica ATH-DSR7BT Manual De Usuario

Using the product
Talking on the phone
• If your Bluetooth device supports telephone features, you can use the product to talk on the phone.
• When your Bluetooth device receives a phone call, the product sounds a ring tone.
• If a call is received while you are listening to music, music playback is paused. When you finish the call, music playback
resumes. *
1
Operation
When
Tap the tap controller
Receiving
a call
Long tap (about 2 seconds) the tap controller
Double-tap the tap controller
Talking on Long tap (about 2 seconds) the tap
a call controller
Slide the volume controller
*1 Depending on your Bluetooth device, music playback may not resume.
*2 When you hear a beep, release the tap controller.
• The phone call controls explained above may not be available on some smartphones.

Auto power off function

The product automatically turns off after 5 minutes of not being connected to a device that has its power turned on.
Listening to music while using a USB connection
You can connect the product to a computer and listen
to music at up to 96 kHz/24 bit from a music player
program while charging the product.
• Read the user manual for the computer.
• Even if the computer meets the requirements
listed in "Specifications for computer connection"
(p.15), these features may not function properly
depending on the computer's hardware and
software.
1. Connect the included USB cable (micro USB Type B side) to the product's USB connector jack.
2. Connect the included USB cable (USB Type A side) to the computer's USB port.
3. Turn on the computer.
4. Configure the computer as necessary.
• Refer to the included "Setup Manual (Computer Settings)" and configure the connected computer according to its
operating system.
5. Refer to "Wearing the product" (p.8) and place the product on your head.
6. Use your computer's music player program to start playing music.
• Adjust the volume as needed using the product, your computer, or your music player program.
• The product's power switch and tap controller are disabled while the product is connected to a computer.
• The product cannot be used as a headset while it is connected to a computer.
11
Function
Answers the call.
Rejects the call.
Ends the call.
Each time you long tap (about 2 seconds) the tap controller, you
switch the call to your Bluetooth device or to the product. *
Adjusts the volume (+ or –) of the call.
USB Type A
Micro USB
Type B
2