Onkyo TX-SR353 Guia De Inicio Rapido página 12

Setup
Automatic Speaker Setting (AccuEQ Room
Calibration)
Position the supplied setup microphone in the
listening position to automatically make the optimum
SETUP MIC
settings to suit the environment of the room, such as
the speaker connections and volume level.
0 Before starting, turn the subwoofer on and raise the
volume.
1. Switch the input on the TV to that assigned to the unit.
2. Connect the setup microphone to the SETUP MIC
jack of the main unit, and place it in the listening
position.
3. Press BD/DVD (a).
4. Press
5. Select AccuEQ Room Cal., and press ENTER (c).
0 Select the item with the cursors of the remote control
a
d
c
6. Press ENTER (c) again.
0 Test tones are emitted by the speakers, and firstly the
b
7. After the results of the above measurements are
displayed, the test tones are emitted again, and
the unit automatically makes settings such as the
optimum volume level and the crossover
frequency. The Setup is displayed once all the
settings are complete.
12
(b).
and press ENTER to confirm your selection (c). To
return to the previous screen, press
S etup
1.AccuEQ Room Cal.
2.Manual SP Setup
3.Input Assign
4.Auto Power Down
5.HDMI Setup
R etu r n
unit detects the speakers connected and the noise in
the environment.
c
b
a
(d).
HDMI Setup
ARC
When connecting to a TV that supports ARC (Audio
Return Channel), enable the ARC feature.
1. Switch the input on the TV to that assigned to the unit.
2. Press (a).
3. Select HDMI Setup, and set ARC to ON in the next
screen.
0 Select the item with the cursors of the remote control
and press ENTER to confirm your selection (b). To
return to the previous screen, press
5. HDMI Setup
a. ARC ON
b. Standby Through
[ LAST
c. 4k60p Setting
Return
4. To exit setup, press (c).
0 You may need to change some TV settings to use
the ARC feature. Please refer to the TV's operation
manual for directions on connections and setup for
the TV.
Standby Through
When the receiver is in standby, the HDMI input signal
selected here will be output to the TV by HDMI. Select
from the following Standby Through items to set.
LAST: The HDMI input signal selected previously
will be output.
BD/DVD, CBL/SAT, STRM BOX, GAME: The
HDMI input signal selected here will be output.
OFF: Signal will not be output during standby.
(c).
]