Audio-Technica ATH-IEX1 Manual De Usuario página 12

About the eartips
■
Size and position
The product comes with silicone eartips in four sizes (XS, S, M and L). At the time
of purchase, the M size silicone eartips are attached and positioned in standard
position.
To ensure the best sound quality and position, select the eartip size that is best
suited for you, and adjust the eartips inside your ears for a snug fit. It may be
difficult to hear bass sounds if the eartips do not fit snugly in your ears.
• Refer to "About COMPLY™ foam eartips" for use of COMPLY™ foam eartips.
■
2 POSITION POST
2 position post maximizes sound isolation while providing a better fit.
1 Eartip cross-
section view
No gap
1. Standard position
The eartips are positioned nearer to the
drivers.
2. Extended position
The eartips are positioned further from the
drivers than the Standard position.
2
Gap
(When M size is attached)
■
Cleaning the eartips
Remove eartips from the product and clean them with a diluted detergent. After
cleaning, dry before use.
■
Replacing the eartip
Remove the old eartip and attach the new
eartip by pushing it onto the headphone at an
angle (see figure). Push firmly on the eartip so
that the inside of the eartip expands, and push
the eartip onto the post as far as it will go.
• The eartips are designed to fit tightly to the
product so that they will not come loose
unintentionally.
• Periodically remove and clean the eartips as they become dirty easily.
Using dirty eartips may cause the headphones themselves to become dirty,
resulting in deteriorated sound quality.
• Eartips are consumable parts that degrade through storage and use. If the
eartips are loose and easily removed or if they appear to have degraded,
purchase replacements.
• When reattaching eartips that were previously removed, be sure to check
that they are securely attached. Injury or illness may occur if the eartips
become detached and are left inside the ear.
3