Stand Removal - NEC MULTEOS M40 Manual Del Usuario

Installation

2) Stand Removal

To detach stand, place the monitor face down as shown
in Figure 2. Remove the screws from the back of the
stand as indicated in Figure 3. Remove the 2 additional
screws located on the bottom of the stand (Figure 3).
Lift up stand to remove. After stand is removed, replace
the screws into the original holes.
NOTE:
The number of screws will vary depending on
the model (Figure 3).
To reattach the stand. Place the monitor face down on
the protective sheet to prevent damage. Remove the
screws from their holes as indicated in Figure 3. Slide
the stand into place, making sure that the inside tabs
located on the left and right of the stand are placed into
the corresponding slots on the display (Figure 4).
The bottom of the stand should fit underneath the
monitor. Use the screws to secure the stand to the
monitor
NOTE:
When removing stand, be sure to remove the
2 screws on the bottom of the stand (Figure 3). Not
removing these screws will result in damage to the
display.
- continued
Figure 3
Figure 4
English-8
Circles indicate screw locations (8).
2 screws under stand