Checking The Parts; Deciding On The Installation Location; Preparing For The Installation Of The Tv - Sony SU-WL400 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16
Installing the TV onto the wall
Installation procedure differs, depending on your
TV.
Follow the instructions in this manual, referring to
the "Installation Guide".
Preparing for installation
 Have the TV's operating instructions at hand
before installation.
 Refer to the "Installation Guide".
 Be sure to have a Phillips screwdriver that fits the
screws prior to the assembly.
 Confirm the installing position of your TV.
 Prepare four or more screws of 8 mm diameter
and one screw of 5 mm or equivalent (not
supplied). Select screws suitable for the material
of the wall.

Checking the parts

 Verify that all the parts are included.
 Identify the parts by their shape, referring to the
"Installation Guide", 1.
 Base (1)
 Pulley ()
 Screw (+PSW6 × 0) ()
 Screw (+PSW × 0) ()
 Spacer ()
 Band (1)
 Screw (+PSW6 × 50) ()
 Bush (M) ()
 Screw (+PSW × 50) ()
Deciding on the installation
location
1
Decide on the installation location.
Refer to the TV installation dimensions table.
For details, refer to the TV's instruction manual.
Allow for suitable clearance between the TV
and the ceiling and protruding parts of the wall
as shown below.
Unit: mm
100
GB

Never install the TV as shown below:
Note
 If you intend to route the cables in the wall, make a hole in
the wall to insert the cables before beginning the
installation.
To prevent pinching the cables, prepare a hole in the wall
somewhere outside the perimeter of the Base  and
Spacer .
2
Decide the positions of the screws
for installing the Base .
Refer to the specifications on page 5.
WARNING
 The wall that the TV will be mounted on should be able to
support a weight of at least four times that of the TV (Refer
to your TV's operating instructions for its weight.).
 Determine the strength of the wall the TV will be mounted
on. Reinforce the wall sufficiently, if necessary.
Installing the Base on the wall
 Use four or more screws of 8 mm diameter or
equivalent (not supplied).
 Install the Base  on the wall horizontally.
Refer to the "Installation Guide", .
Preparing for the installation of
the TV
Prepare installation of the TV, following the TV's
instruction manual.
100
Air circulation is
blocked.
Wall

Publicidad

Tabla de contenido
loading

Tabla de contenido