Operating Your Appliance; Temperature Control - Avanti BCC6Q1BG Manual De Instrucciones

Enfriador de bebidas comercial
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

IMPORTANT SAFEGUARDS:
DO NOT STORE FOOD IN THE BEVERAGE CENTER, AS INTERIOR TEMPERATURE MAY NOT GET
COOL ENOUGH TO PREVENT SPOILAGE.
AS A NATURAL RESULT OF CONDENSATION, IN SUMMER MONTHS OR AREAS OF HIGH
HUMIDITY, THE GLASS DOOR MAY BUILD UP MOISTURE ON THE OUTSIDE.
SIMPLY WIPE IT AWAY.
It is recommended that you install the appliance in a place where the ambient temperature is between
72º - 78ºF (22º - 26ºC). If the ambient temperature is above or below the recommended temperatures,
the performance of the unit may be affected. For example, placing your unit in extreme cold or hot
conditions may cause interior temperatures to fluctuate. The range of 34º - 43ºF (1º-6ºC) may not be
reached.
This beverage cooler is designed to operate with a range of 34º- 43ºF (1º- 6ºC).
ON/OFF Power
Your unit is designed to turn ON as soon as the power cord has been plugged into an active
power source.
Attention:
This unit is equipped with a power delay system to protect the compressor in the event of a power
outage.
• This power delay system will delay the compressor start cycle for "3" three minutes both at the
first time the unit is plugged in and when there is a power outage.
• Once the unit is plugged in for the first time or power has been restored to the unit, the
compressor will start cycling after (3) three minutes of uninterrupted power supply.
• Display Lighting and Interior Lighting will work as normal and not be affected.

Temperature Control

The manual temperature control knob is located in the upper right hand side of
the compartment.
The range of the temperature controls from:
"0" (NO Cooling) to "7" (Coldest Setting)
The first time you power the unit on, turn the temperature control to position 7
and allow the interior to cool down before adding any items.
After 24 to 48 hours, adjust the temperature control to the setting that best suits your needs; in most
applications the setting of "4" – "5" should be adequate for general use.
To turn off the cooling system, unplug the unit from the electrical outlet.
Note:
Also, as cold air fall and warm air rises, there could be a slight temperature
variance between the top and bottom shelves.
Interior Light
You can turn the interior light on or off by pressing the toggle switch marked Interior Light on the
control panel located at the outer upper left side of the unit.

OPERATING YOUR APPLIANCE

9

Publicidad

Tabla de contenido
loading

Tabla de contenido