Adjusting The Anti-Skating; Turning The Power On; About This Unit's Standby Modes - Yamaha MusicCast VINYL 500 Manual De Instrucciones

|
Getting ready

Turning the power on

Adjusting the anti-skating

As the platter rotates, the tip of the stylus generates a force that pulls it toward
the center of rotation. If the anti-skating value is set to the same value as the
stylus pressure, a force is generated that pulls the tip of the stylus outward
away from the center of rotation, and the two forces cancel each other.
1
Turn the anti-skating adjustment to the same value as the stylus
pressure of the cartridge.
22
En
Turning the power on
On the top panel of the unit, press STANDBY/ON (power) to turn on the power
of the unit. Press STANDBY/ON (power) once again to put the unit in standby
mode.
STANDBY/ON
(power)
NOTE

When you first turn on the power after purchasing the unit or initializing it, the
(wireless LAN) indicator might flash. If it flashes, you can connect to the
wireless network by sharing the network settings of your iOS device. ( page 35)
In order to enjoy music from a variety of network sources, use MusicCast
CONTROLLER to connect to your network. ( page 23)

About this unit's standby modes

This unit has two types of standby mode.
Network standby: This device's power can be turned on from a network
device. (only when the audio output select switch is set to LINE OUT)
Eco standby: This mode reduces the standby power consumption.
NOTE

If you want to switch to the eco standby setting, you can use your web
browser to change the Standby setting. ( page 33)

If you want to temporarily switch to eco standby, hold down STANDBY/ON
(power) for five seconds while the unit is powered-on. (only when the audio
output select switch is set to LINE OUT)