INSTALLATION INSTRUCTIONS
REQUIRED TOOLS
• 1/4" nut driver
• 3/8" socket with ratchet
• 3/8" open end wrench
• Adjustable wrench or 7/16" socket with ratchet
• Adjustable wrench or 9/16" open end wrench
• Channel lock adjustable pliers
• Carpenter's level
LOCATION
• The location must be large enough to allow the
appliance door to open fully. The door can open
more than 90° and is not reversible.
• It is recommended to allow 2.5 cm of space on
all sides of the appliance to reduce noise.
• The fl oor must be level and strong enough to
support the appliance when it is fully loaded.
• It is not recommended to install this appliance on
carpeting.
• The appliance must be located within 1.2 m (4
feet) of the water source and a drain.
• The appliance must be located within 1.8 m (6
feet) of a properly grounded power outlet.
• Do not operate this appliance in temperatures
below 0°C (32°F) as water inside the hoses
or appliance could freeze and damage the
appliance.
• Avoid placing the appliance in direct sunlight.
• Do not place the appliance near heat sources.
INCLUDED ACCESSORIES
1. Two water hoses
2. Four transport hole plugs
1
DIMENSIONS
108 cm
(42.5")
5
2
59.5 cm
(23.5")
85 cm
(33.5")
59.5 cm
(23.5")