Water Supply - Danby DWM120WDB-3 Manual Del Propietário

INSTALLATION INSTRUCTIONS
INLET HOSE CONNECTION
This appliance can be connected using one hose
or two, depending on how many connections are
available at the water supply.
If only one faucet is available, use the cold water
connection on the back of the appliance. If two
faucets are available, then both water connections
can be used.
First, connect the provided inlet hoses to the back of
the appliance. The hot water connection is on the
left and the cold water connection is on the right.

WATER SUPPLY

Connect the inlet hoses to the water supply faucets.
Tighten the connections with a wrench.
Turn on the water supply before using the appliance
and ensure that there are no leaks at any water
connections.
DRAIN HOSE INSTALLATION
The drain hose will arrive pre-attached to the
appliance. When running the drain hose toward a
sink, standpipe or drain, ensure that there are no
bends in the hose as this can cause a blockage and
impede the drain function.
Standpipe drain system
A standpipe drain requires a minimum diameter of
2" (5 cm). The capacity must be at least 17 gallons
(64 liters) per minute. The top of the standpipe must
be at least 60 cm high and no higher than 100 cm
from the bottom of the washer.
Laundry tub drain system
The laundry tub must have a minimum capacity of
20 gallons (76 liters). The top of the laundry tub
must be at least 60 cm above the fl oor.
Floor drain system
The fl oor drain system requires a siphon break that
must be purchased separately. The siphon break
must be a minimum of 28" (71 cm) from the bottom
of the washer.
7