Milwaukee 2676-20 Manual Del Operador página 4

SYMBOLOGY
Volts
Direct Current
UL Listing for Canada and U.S.
US
C
WARNING
live electrical panels.
WARNING
Fingers could be crushed or severed.
Always wear eye protection
Read Operator's Manual
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove battery pack before
WARNING
changing or removing accessories.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Only use accessories specifically
WARNING
recommended for this tool. Others
may be hazardous.
Assemblying the Draw Stud and Ball Pull
Determine whether to use the Rapid Reset Draw Stud
Set or the standard draw stud/ball pull. NOTE: The
Rapid Reset Draw Stud Set cannot be used without
the Quick Connect Assembly.
Rapid Reset Draw Stud Set
1. Insert the short-grooved end of the draw stud into
the ball pull.
2. Turn the draw stud slightly to lock into the ball pull.
The draw stud will "click" into place.
Standard Draw Stud and Ball Pull
1. Insert the short-threaded end of the draw stud
into the ball pull.
2. Screw the draw stud into the ball pull. Tighten
securely.
Installing/Removing the
Quick Connect Assembly
The Knockout Tool can be used with
the Quick Connect Assembly, or with
the standard draw stud screwed
directly into the tool.
1. Remove the battery pack.
2. Screw the coupler into the piston.
Hand-tighten securely.
3. Place the Quick Connect Assem-
bly over the collar of the tool. Pull
back on the sleeve and slide over
the collar. Release the sleeve.
4. To remove the Quick Connect
Assembly, reverse the procedure.
Risk of electric shock.
Do not use in or near
Keep hands away
from punch and die.
Installing/Removing the Draw Stud
In some circumstances, such as working in tight
spaces, it may be necessary to use the Knockout
Tool without the Quick Connect Assembly.
1. Remove the battery pack.
2. Remove the Quick Connect Assembly.
3. Screw the standard draw stud directly into the
piston. Hand tighten securely. NOTE: The Rapid
Reset Draw Stud Set cannot be used without the
Quick Connect Assembly.
4. To remove the draw stud, unscrew from the piston.
FORCELOGIC™ Adapter (some models)
Use the MILWAUKEE FORCELOGIC™ Adapter
(Cat. No. 49-16-2685) to properly fit other major brands
of small and large punches and dies. Use with other
major brand draw studs and spacers, as required.
3/4" x 3/8"
or 7/16"
Draw Stud
Spacer
(if needed)
Small Die
Small
Punch
Large Punch
3/4" x 1-1/8"
Thread Adapter
OPERATION
Always remove battery pack before
WARNING
changing or removing accesso-
ries. Only use accessories specifically recom-
mended for this tool. Others may be hazardous.
To reduce the risk of injury, always wear safety
goggles or glasses with side shields.
To reduce the risk of injury, ensure all threads
are hand-tightened securely before operating
knockout tool.
• Before beginning a punch, inspect and discard mate-
rial and accessories with cracks or other damage.
• Before beginning a punch, check the fuel gauge to
determine whether the battery charge is sufficient
to complete the operation.
• Do not attempt to punch through more than one
layer of material at a time.
4
FORCELOGIC™
49-16-2685
3/4" Draw
Punching
Adapter
Stud
Large
Die