mesabiotech Accula DOCK Manual Del Operador página 9

If the cassette has been properly inserted, the display will identify the type of test that is supported by
the cassette, for example:
4. After a few seconds the display will prompt the user to add the sample to the cassette sample port:
The Test cassette is now ready to accept the sample.
To avoid contamination, do not remove the foil tab
covering the cassette sample port until you are ready to add the sample.
Running the Assay
After starting the test, avoid bumping, tilting, or otherwise disturbing the Accula
Dock, as this may cause the test to abort.
1. Per the test kit instructions, remove the foil tab from the Test cassette and immediately add the sample
to the cassette sample port. The Accula™ Dock will beep upon sensing the sample, and display:
The Dock will then beep once every second until the lid is closed.
2. Close the lid, pressing it into place over the top of the Test Cassette until it clicks into its locked
position. The Dock will then display:
The Dock will verify that the Test Cassette has been sealed. Once verified it will initiate the test
and display:
During the test, the Dock will display an estimated time to completion. For example:
Accula™ Dock Operator's Guide
60007 Rev H
If the display shows an error, refer to Section
E - Troubleshooting for additional information.
CASSETTE SEALED
REMAINING: 25:15
The remaining time is an estimate of the time required to run the assay. The actual time
remaining is determined by a number of factors, including ambient temperature, altitude,
and the type of assay being run.
During a test run, you will hear the whir of a fan and flow of air through the Dock. This is
perfectly normal behavior, and is not indicative of a Dock malfunction.
FLU A/FLU B
CASS. INSERTED
ADD SAMPLE
THEN CLOSE LID
SAMPLE LOADED
CLOSE LID
SAMPLE LOADED
LID CLOSED
TEST STARTED
TEST RUNNING
™
7