Yamaha GT-5000 Manual De Instrucciones página 15

Ocultar thumbs Ver también para GT-5000:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1
Install the sub platter onto the center
spindle
NOTICE
Do not apply force to the center spindle when
you install the sub platter onto the center
spindle. Otherwise, the center spindle might
be damaged.
2
Install the belt around the sub platter
and pulley
Make sure that the belt is not twisted.
Rotate the sub platter clockwise to ensure that the
belt will be well seated.
3
Screw the handles into the platter,
and then lift the platter by holding the
handles
CAUTION
Take care not to drop the platter. Dropping it
might cause injury, or damage the unit.
4
Install the platter onto the center
spindle
Remove the handles from the platter.
5
Place the turntable mat on the platter
Note
• You can use the rubber or felt turntable mat.
• The side of the rubber turntable mat with a dent
in the center should face upward.
6
Attach the dial cover to the PITCH
ADJUST
7
Attach the counter weight to the
tonearm
With the markings on the counter weight facing
you, slide it onto the back end of the tonearm.
Note
Depending on the weight of the cartridge, install
the large or small counter weight. For information
about acceptable cartridge weights for each
counter weight, refer to the "Specifications"
section on page 28.
15

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido