Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
direction - Fig.9.
• Tighten fittings, introduce the heat-shrinking hose C
and use a small heat source to warm it up. Make sure
that fittings are completely covered.
• Reconnect connectors A and B, screw in the handle M
and then the retention dowel G.
• Reposition the sleeve onto the handle and tighten the
clamp F1.
5.6 REPLACING
THE
ADAPTER.
J
P
AB
AC
W
CABLE
WITH
CENTRAL
T
X
M
I1
Y
Y1
Fig. 10
Fig. 7
Fig. 8
Fig. 9
Remove spring P and cut the clamps that fasten the cable
J. Open the cover W by unscrewing the 4 set screws and
then screw M. Remove pins of the control cable X and
Z. Take note of the position of each pin and then remove
the U-bolt T and the pins of the pilot arc red cables Y
and Y1. Cut the isolating hose K2 and unscrew body N
from fitting I1. Assemble the new fitting and follow the
previous instructions in reverse direction. Use thread
sealer to lock the N body thread. To avoid jeopardizing
the safety efficiency, the body contacts N must be
connected as follows: pins Y and Y1 of pilot arc red
cables to contacts 5 and 6, pin X of cable J to contact
1, pin Z of cable J to contact 9.
Z
N
Reconnect U-bolt T as described above.
5.7
WARNINGS
Periodically make sure that the welding torch cable is
intact and has no cuts or excessive wear. Replace it
immediately if needed.
K2
11
Publicidad
Tabla de contenido
