Cebora CP-161 Manual De Instrucciones página 9

Fig. 1
Note 2:
• With welding torch CP 161 DAR, used on units with no
interface circuit, operation start is obtained with cable
wires AB. In this case when cutting operation is
completed, the start contact must be positioned in
open position (OFF).
• With welding torch CP 161 DAR, used on units with
interface circuit, the cable AB wires must be always
short circuited.
5.3 REPLACING THE WELDING TORCH BODY
THIS SECTION IS RESERVED TO SKILLED PERSONNEL
ONLY.
5.3.1 Replacing the welding torch body CP161 MAR
• Unscrew the 6 screws V Fig.3 and remove the LH grip.
• With reference to Fig.4, lift the welding torch body T with
cable and disconnect connector A (push-button) and
connector B (pilot arc) making sure that the push-button
9