Product Familiarisation; Before Use - Silverline 262258 Manual De Uso

GB

Product Familiarisation

1 Vacuum Tubes
2 Auxiliary Handle
3 Shoulder Strap
4 On/Off Switch
5 Main Handle
6 Selection Lever
7 Debris Exhaust
8 Vacuum Bag

Before Use

Ensure that all parts of your vacuum blower are present and in good
condition. If any part is missing, or damaged, have such parts replaced
before attempting to use this tool
Operating Instructions
Vacuum tubes:
• Attach the Vacuum Tubes (1) prior to usage using the screws and bolts
provided
NOTE: If the tubes are incorrectly fitted to the unit it could result in a severe
loss in performance.
Vacuum bag:
• Attach the Vacuum Bag (8) to the Debris Exhaust (7), use the self tapping
screws that are provided
Shoulder strap:
• Attach the Shoulder Strap (3) to the unit prior to use, adjust the strap so
that the unit falls comfortably around the waist
NOTE: Do not use the unit without the shoulder strap.
Auxiliary handle:
• Prior to use adjust the Auxiliary Handle (2) to best suit the user
• To adjust the handle, loosen the securing knob and move the handle into
its required position
• Once in position tighten the knob ensuring that the locating teeth have
fully engaged
Using your Vacuum Blower
Operating as a blower
1. Ensure the Selection Lever (6) is in the horizontal position; this changes
the unit to blower mode
2. Turn the blower on by moving the On/Off Switch (4) to the 'I' position
3. Grip the vacuum blower by both handles (2 & 5) and point directly at
the debris
4. Sweep the unit gently from side to side, blowing the debris into one
location
NOTE: Ensure the end of the unit is always at least 15cm above the ground
NOTE: If performance seems to be restricted, you may need to remove the
vacuum bag.
5. When finished, turn the vacuum blower off by moving the On/Off Switch
(4) into the '0' position
Operating as a vacuum
1. Ensure the Selection Lever (6) is in the vertical position; this changes the
unit to vacuum mode
2. Turn the vacuum on by moving the On/Off Switch (4) into the 'I' position
3. Grip the vacuum blower by both handles (2 & 5) and point directly at
the debris
4. Sweep the unit gently from side to side as it sucks up the debris
NOTE: Ensure the end of the unit is always at least 15cm above the ground
6
NOTE: Ensure the vacuum bag is securely attached to the unit
5. When finished, turn the vacuum/blower off by switching the On/Off
Switch (4) to the '0' position
WARNING: Ensure the selection lever is not half-way between the blower
and vacuum selections as this could cause damage to the unit and may
invalidate the warranty.
Maintenance
Always turn off the vacuum blower, and allow to cool fully, before
performing any cleaning or maintenance.
Cleaning
• Keep your machine clean at all times. Dirt and dust will cause internal
parts to wear quickly, and shorten the machine's service life
• Use a dry cloth or brush to remove any debris that may be blocking the
vents