Technical Specifications - Nilfisk MC1200 Información E Instrucciones De Uso

New & Reconditioned Equipment & Parts- www.southeasternequipment.net
A - ENGLISH
TROUBLESHOOTING:
IF THIS OCCURS
NO SPRAY
LOW PUMP PRESSURE
PUMP DOES NOT RUN
LOW SUCTION
NO SUCTION
LOW HEAT
NO HEAT

TECHNICAL SPECIFICATIONS

Rotomolded Body:
Vacuum:
VAC Shutoff:
Pump:
Heat:
Capacity:
Cords:
Size:
Auto dump:
Wheels:
Hoses:
Plus:
A-14
INSTRUCTIONS FOR USE
CHECK THIS
Holding Tank is empty, or fi lter is plugged.
Clogged spray tip(s).
Pump not running or not primed.
Valve on wand not operating.
Solution hose not completely connected to hose or to machine.
Check to see that the pressure relief valve is fully closed.
This pump motor runs on AC voltage, so it should start running as soon as you turn on the switch. If the pump
motor does not start running, check the wiring to the switch and to the motor. Check the switch to see if it is "open".
Debris is plugging cleaning tool or vacuum hose.
Drain hose cap is not completely closed.
Recovery tank lid is not seated or gasket is damaged.
Ball in the fl oat is blocking air fl ow. Turn off the vacuum so the ball will drop down, or the recovery tank is full and
needs to be emptied.
No power to motor(s).
Test the switches.
Test the vacuum motors.
Spraying too long. Try spraying for 12-15 seconds, or about three strokes.
Heat exchanger needs to be fl ushed.
Wrong tool being used. Too much water passing through. Longer hose or larger diameter hose, than standard.
Heat is not turned on. The green circuit indicator light must be on.
No power in the wall outlet - check to see if the breaker has tripped.
Call your distributor for additional help.
Lifetime Warranty
7.2" 3-stage, 140" of water lift
Ball Float
Positive displacement, fully adjustable 0-500 psi & Positive displacement, 1200 psi, 2.2 gpm
2000 Watts, up to 212 °F
16 gallon Holding Tank; 14 gallon recovery tank
Two, detachable 12/3, hospital grade plugs
39" H X 21" W X 36" L
5 gpm
10", locking, non-marking
25 ft hoses on a reel (patent pending)
Auto-fi ll and a Power Prime system for the 1200 psi pump
MC1200 - 56042670
New & Reconditioned Equipment - www.southeasternequipment.net
9/2016