Installing The Speakers - Yamaha AVX-S80 Manual De Instrucciones

SPEAKER SETUP

Installing the speakers

I Placing the center speaker
Place the speaker on TV whose top is flat or on the floor
under the TV or inside the TV rack so that it is stabilized.
When placing the speaker on top of the TV, to prevent the
speaker from falling down, put the provided fasteners at
two points on the bottom of the speaker and the top of the
TV.
Fastener
Peel off the
seal
Cautions
• Do not place the speaker on top of the TV whose area is
smaller than the bottom area of the speaker. If placed, the
speaker may drop out causing an injury to you.
• Do not place the speaker on top of the TV with an inclination.
• Do not touch the adhesive surface after peeling off the seal as
this will weaken its adhesive strength.
• Thoroughly wipe clean the surface where the fastener is to be
applied. Note that adhesive strength is weakened if the surface
is dirty, oily or wet and that this may cause the center speaker
to drop.
I Placing the front and rear
speakers
When placing the front and rear speakers on a flat
surface, attach the included non-skid pads to the corners
on the bottom of the speakers as shown below. This
prevents the speakers from sliding around.
10
E3-S80-8-18(6.29)a
Non-skid pad
10
I Mounting the front and rear
speakers on a wall
When mounting the speakers on a wall, use the holes on
the speakers' back panels.
1
Fasten screws into a firm wall or wall
support as shown in the figure.
Tapping screw
(Available at the
hardware store)
Diam. 3.5 to 4 mm
70 mm 70 mm
10 mm
Min.
20 mm
2
Hang the holes on the protruding screws.
Make sure that the screws are securely caught by the
narrow parts of the holes.
70 mm
Warning
• Each speaker weighs 0.9 kg (11 lbs. 16 oz.). Do not mount
them on thin plywood or a wall with soft surface material. If
mounted, the screws may come out of the flimsy surface and
the speakers may fall. This damages the speakers or causes
personal injury.
• Do not install the speakers to a wall with nails, adhesives, or
any other unstable hardware. Long-term use and vibrations
may cause them to fall.
• To avoid accidents resulting from tripping over loose speaker
cables, fix them to the wall.
• Select a proper position on the wall to mount the speaker so
that no one will injure his/her head or face.
02.6.29, 4:32 AM