Placing The Speakers Using The Stands; Placing The Speakers On A Wall - Yamaha DVX-700 Manual De Instrucciones

CONNECTIONS
■ Placing the speakers using the
stands
You can place the speakers in an upright position or a
horizontal position. Put the speakers on the stands and
secure them with the screws.
When placing the speaker in an
upright position
Place the speaker on the stand vertically, and then secure it
with the screw as shown in the illustration.
When placing the speakers in a
horizontal position
Put the speaker on the stand so that the black side of the
speaker becomes outside, and then secure it with the screw
as shown in the illustration.
12
En

■ Placing the speakers on a wall

Put the speakers on a wall using commercially available
screws. Refer to the illustration below for the screw size.
Tapping screw (Available at the hardware store)
Dia.4 mm (1/8")
Installing on a plaster wall.
Min 20 mm 5 mm
(3/4") (1/4")
Pillar Plaster
or lumber
1 When placing the speakers on a wall, remove the
stands.
2 Install screws on a wall as shown in the illustration.
The distance between the screws: 126 mm for both
sides
126 mm (5")
3 Insert the screws into the holes on the back of the
speaker.
Notes
– To attach the speaker to a wall with screws, the
wall must be firm. If not you may cause the speaker
to fall.
Installing on a firm wall.
Min 20 mm 5 mm
(3/4") (1/4")
Pillar
or lumber
126 mm (5")