Signal Check (Rgb Mode) - Yamaha PDM-4220 Manual Del Usuario

OTHER FUNCTIONS (continued)
DVD Player Selection (continued)
Set up hint
Example) YAMAHA 1 DVD (
To operate the YAMAHA DVD player, set the FUNCTION SELECT
switch to the DVD position.
1. Set up the maker.
Press and hold the
more than 1 second.
2. Set up the type.
6
Release the button whilst keeping
1
Then, press the for more than 1 second.
3. Confirm the setting.
After setting the maker and type, press the STANDBY/ON button
on the remote control. If the DVD does not switch on, repeat step
1 and 2 using other types ( in this case,
on .
41
NOTE
• Not all models of the listed makers can be operated using this
remote control.

Signal Check (RGB mode)

Changes in the signal status are displayed on the screen as they arise.
Status
When Mode Display is set to ON,
the input signal is switched or
when the RECALL button is
pressed.
When the sync signal is no longer
detected.
When the input signal does not
match the monitor specifications
or is in an unstable state.
42
6
)
button, and followed by pressing
button depressed.
2
)as listed in the chart
Display
A guide is displayed for the input
terminal and the horizontal and
vertical sync frequency.
• A guide displays No Sync.
Signal, and Power Save (for
approx. 5 sec.)
• When the condition continues
where the sync signal cannot be
detected, indicator lamp of
power source changes in
orange and the mode switches
to power save mode.
A duide displays Invalid Scan
Freq.
6
for
Action
––––––––––
Recheck the personal computer
power switch status and the
connection status.
Recheck the input signal
specifications.
48 ~ 50
FUNCTION SELECT
switch
STANDBY/ON
RECALL
TV DVD
RECALL button
+
i
/I
AV 1 AV 2 AV 3 AV 4
AV 5 AV 6 RGB 1 RGB 2
1 2 3
PROGRAM SELECT
4 5 6
buttons
7 8 9
0
2-4-12
MENU RETURN
OK
A. MODE P. MODE
VOL PROG
+
+
P
I/II
P
?
i
RGB
-- -- Min.
OFF
-- -- : -- --
! No Sync. Signal
! Invalid Scan Freq.
RGB2
RGB
H : 48.4kHz
V : 60.1 Hz