Optional Video Unit Function; Connecting To A Video Imaging Device - Yamaha PDM-4210E Manual De Usuario

Optional Video Unit Function

Additional functions when the optional video unit is installed are as follows: (
INSTALLATION INSTRUCTIONS

Connecting to a Video Imaging Device

(1) Make sure that the power switch of the monitor is turned off.
(2) Make sure that the power switch of the imaging device is turned off.
(3) Use a commercially available cable and connector to connect the signal input terminal on the rear panel of this
device and the signal output terminal of the imaging device.
VCR
To SCART
terminal
Set-Top Box
DVI-STB and RGB component setup
Applicable video signals for each input terminal (See PRODUCT SPECIFICATIONS for details.
Terminal RCA/SCART
Signal CVBS S-video
AV1
AV2
AV3
AV4
RGB1
RGB2
20 18 16 14 12 10 8 6 4 2
21 19 17 15 13 11 9 7 5 3 1
VCR
To component video
equipment.
Please use connection
cable suitable for the terminal
form of video equipment.
Component RGB PC
31 42
~
Speaker (R)
Monitor rear panel
EUROPE U.K. ONLY
Power
cord
To RGB,
video and audio
input terminals
[An example of connecting video imaging devices]
Use if the
video
equipment
has an
S video
input terminal
• If video equipment with an S video output terminal is used,
connection with S video cable is recommended to provide finer
video quality. (If the S video input terminal and the video input
terminal of AV3 connect to the monitor at the same time, S video
input would govern.)
• If the OUTPUT (MONITOR) terminal is connected to an external
monitor with a 75 Ohm terminal, it is possible to view the same
image as on the main unit. But it is possible to monitor only the
composite video signal from AV1, AV2, AV3, or AV4 input that is
displayed on the screen at the time.
DVI D-sub
STB RGB Component
)
Speaker (L)
DVD player DVD player
Remarks
Refer to Setup Menu. 38
Refer to Setup Menu.
38
Refer to Setup Menu. 39
39
Refer to Setup Menu.
(
40
)
: Available)
31