Yamaha PDM-4210E Manual De Usuario página 40

OPERATING INSTRUCTIONS (continued)
SETUP MENU (continued)
Selected characters
Audio Input
AV1
AV2
AV3
AV4
Scart Output
RGB1
RGB2 (1st step)
RGB2 (2nd step)
OTHER FEATURES
Automatic Store
Approximately 1 sec. after adjustment is completed, the adjustments will be recorded as shown in the table below.
Menu Display
Picture
Picture Mode
Contrast
Brightness
Colour
Sharpness
Hue
Colour Temperature
Contrast Mode
YNR
CNR
Film Mode
PAL Comb Filter
LTI
CTI
Black Enhancement
Auto Colour
Colour Temp. Adjust
R Amplitude For every Colour Temperature, 1
G Amplitude
B Amplitude
R Cut Off
G Cut Off
B Cut Off
Colour Management
Magenta 1 setting is registered.
Red
Stereo L/Mono
DVI-PC DVI-STB
RGB Component
Auto HDTV SDTV/DVD
Registration condition
1 setting is registered.
For every input function and every
Picture Mode, 1 setting is
registered.
setting is registered.
For every input function and every
Picture Mode, 1 setting is
registered.
This should correspond to the audio signal from the equipment that is
connected to the AV1 audio input terminal. If the signal is monaural audio,
set this to L/Mono.
(Same to AV1)
Not Available (grayed out)
This should correspond to the signal mode of the signal from the
equipment that is connected to the RGB1 DVI terminal.
This should correspond to the signal mode of the signal from the
equipment that is connected to the RGB2 D-sub terminal.
This step should be set only when [Component] is selected on the 1st
step.
This should correspond to the signal mode of the signal from the
equipment that is connected to the RGB2 D-sub terminal.
• Normally, set this to Auto. The signal mode of the input signal will be
automatically recognized.
• If the input signal contains a lot of noise or has a low level at Auto and the
operation is found erratic, set this to match the input signal.
Menu Display
Picture Yellow 1 setting is registered.
Green
Cyan
Blue
Colour Decoding
Red For every Colour Temperature, 1
Green
Colour For every input function and every
Hue
Function
Video Power Save
Default Zoom
Setup
System
Colour System
AV1
AV2
AV3
AV4
Video Input
AV1 1 setting is registered.
AV2
AV4
Audio Input
AV1 1 setting is registered.
AV2
AV3
AV4
RGB1
RGB2
• The previously recorded items will be lost.
Setup hint
Registration condition
-
setting is registered.
Picture Mode, 1 setting is
registered.
1 setting is registered.
1 setting is registered.
1 setting is registered.
-
-
39