Surfaces; Stainless Steel Surfaces (On Some Models); Lights - GE JVW5301 Manual Del Propietário

Surfaces

Stainless Steel Surfaces (on some models)

Do not use a steel wool pad; it will scratch the surface.
To clean the stainless steel surface, use warm sudsy
water or a stainless steel cleaner or polish. Always wipe
the surface in the direction of the brush line. Follow
the cleaner instructions for cleaning the stainless steel
surface. Cleaners with oxalic acid such as Bar Keepers
Friend Soft Cleanser™ will remove surface rust,
tarnish, and small blemishes. Use only a liquid cleanser
free of grit and rub in the direction of the brush lines with
a damp soft sponge.
Painted Surfaces (on some models)
Do not use a steel wool pads or other abrasive
cleaners; they will scratch the surface.
Clean grease-laden surfaces of the hood frequently. To
clean the hood surface, use a hot, damp cloth with a
mild detergent suitable for painted surfaces. About one
tablespoon of ammonia may be added to the water. Use
a clean, hot, damp cloth to remove soap. Dry with a dry,
clean cloth.
Lights (Pyramid Models JVW5301, JVW5361)
CAUTION
Allow lights to cool before touching.
To change the lights:
1. Before attempting to replace the lights, make sure that
the light switch is turned off.
2. Using a flathead screwdriver, unclip the wire lighting
support and gently pull the support down from the
hood.
3. While holding the socket, twist the light counter-
clockwise to remove. Replace it with a new GU-10
light. Make sure the new light is locked in the socket.
4. Replace the new light and socket into the hood and
engage into the light support.
8
To inquire about purchasing stainless steel appliance
cleaner or polish, or to find the location of a dealer
nearest you, please call our toll-free number:
National Parts Center
800.626.2002
GEApplianceParts.com
NOTE: When cleaning, take care not to come in contact
with filters and other surfaces.
CAUTION
When cleaning the hood surfaces,
be certain that you do not touch the light with moist
hands or cloth. A warm or hot light may break if
touched with a moist surface. Always let the light
cool completely before cleaning around it.
49-80760-2