Target Priority Mode/Disance Display Units/Others - Nikon COOLSHOT 20 Manual De Instrucciones

Target priority mode
This Laser Rangefinder has a First
En
Target Priority System. When measuring
Es
overlapping subjects, this equipment
Fr
displays the distance to the closest subject.
Pt
Others
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules and to EU EMC directive. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
This Nikon Laser Rangefinder is a basic rangefinder. Its results cannot be used as official evidence.
14
Distance display units
Measurement results are displayed in yards/meters.
(Factory default setting is yard.)
Yard [ ]
1. Turn on the power (Confirm the internal display is on).
2. Press and hold the MODE button for more than two seconds.
When the display unit has been switched, release the button.
3. After the unit is set, results will be converted and displayed in
the selected distance display unit.
Meter [ ]