Quilo QP110 Manual Del Propietário página 12

INSTALLATION
It is important that the installation instructions below are followed for successful installation of this Quilo
Portable Air Conditioner. Please call Customer Support if you have any difficulties or queries regarding these
installation procedures.
1
Installation Kit:
1. Window Bracket Kit
2. Window Bracket Panel Adapter
3. Plastic Pin
Installation Steps:
1. Install the exhaust hose with window bracket panel adapter and hose connector on both sides. Ensure
proper fit on both ends.
2. Adjust the window bracket as per width or height of your window and insert the plastic pins to fix at the
desired position. There is a hole where the exhaust hose will be inserted later.
Make sure this hole is not blocked.
2
x1
5
(1 Set)
(1 Piece)
(2 Pieces)
26.6", 36.2" to 52"
(67.5cm, 92cm to 132cm)
3
x1 x2
6
x1
4. Hose Connector
5. Exhaust Hose
6. Drain Tube (refer to Continuous
Draining for Dehumidifier Mode)
Plastic Pin
Hole for Window Bracket
Panel Adapter & Exhaust Hose
EN
3
4
x1
x1
(1 Piece)
(1 Piece)
(1 Piece)
TM
EN