Quilo QP110 Manual Del Propietário página 22

TROUBLESHOOTING GUIDE (CONTINUED)
PROBLEM
Runs but not cooling
Will not run and
Power button is
blinking (water full
indicator)
Heater* is not
switching ON
(This may only
be applicable for
TM
Quilo Portable Air
Conditioner models
with built-in Heating
function only).
POSSIBLE CAUSE
A door or window is open.
The dust filter is dirty.
The exhaust hose is
detached.
Temperature setting is too
high.
Air outlet or intake is
blocked.
Room exceeds
recommended size.
Large size or number of
windows are decreasing
cooling effectiveness.
Excess water
condensation inside
the tank.
Heating* function not
activated yet.
The ambient temperature
is too high.
Heating* is activated
only when the ambient
temperature is below 25°C
(77°F).
SOLUTION
Make sure the window or door is closed.
Clean the dust filter.
Reinstall exhaust hose properly
(refer to Installation section).
Reduce temperature setting on control panel.
Remove blockage.
Move unit to smaller room.
Cover windows with curtains or blinds.
Drain the water (refer to Water Condensation Drainage).
Check that the Heating* function has been activated.
will be illuminated when the Heater is switched ON.
Switch on the Heating* function when the ambient
temperature reaches below 25°C (77°F).
EN
13
*Applicable for models with Heating feature only.
EN