TECshow DMX PINSPOT LED BAR Manual De Usuario página 7

Important: After the installation is completed, please
check the installation line first, confirm the installa-
tion without error, without electrical short circuit, and
connect the corresponding control power.
Multiple installation
The DXM Pinspot LED Bar is equipped with a power
output that allows more DXM Pinspot LED Bar to be
used in series with each other without occupying
additional electrical outlets.
Important: The maximum load current at this pow-
er supply output cannot exceed 30 units.
Set Up
1. Open the shipping carton and carefully remove
the device from the shipping carton;
2. Be sure to remove packing material from
around the device, especially in the vicinity of
the LED light source;
3. Install the device in the appropriate place, and
fix it well;
4. Plug mains power cord from the device into
appropriate power supply socket;
5. If the cable is not long enough, please connect
with the standard and good quality extension
cable.
| Tecshow DMX Pinspot LED Bar
English version
P. 7