Tabla de contenido
Publicidad
GB
IMPORTANT INSTALLATION ADVICE
- The automation system must be installed to good workmanship standards by qualified staff meeting the legal
prerequisites, in accordance with machinery directive 2006/42/EC.
- Check the condition of any wiring already installed in the system.
- Analyse the risks of the automation system and adopt any appropriate safety and warning measures.
- Install cont rols such as the key -swi tch in such a way that the user is not in a hazard zone.
- After installation, try out the automation safety, signalling and release devices several times.
- Apply the CE lab l or nameplate containing the hazard information and ID information to the automation. .
- Consign the instructions for use, safety information and EC declaration of conformity to the final user.
- Ensure that the user has understood how to operate the automation correctly in automatic, manual and emergency
modes.
- Inform the user in writing (for example, in the operating instructions):
* of any residual risks for which no protection is provided, and foreseeable misuse .
* That the power supply must be disconnected in the event of cleaning in the area of the automation, or minor maintenance
work (e.g. repainting).
* That the automation must be inspected frequently for visible damage, informing the installer immediately if any damage is
found.
* That children must not be allowed to play in the immediate vicinity of the automation.
- That a maintenance schedule must be drawn up for the plant (at least every six months for the safety devices), recording
work done in a specific log.
SPRING SELECTION
Bar type
RAPPER4TL
SNAPPER4
SNAPPER4 + PSR
SNAPPER4 + SRS
SNAPPER4 + SRS + PSR
CHARACTERISTICS
The SNAP4 is an electromechanical barrier suitable for use on the accesses to car parks, factories, public buildings, hospitals,
apartment buildings, etc.
It consists of a cabinet containing the gear motor and control unit. The drive system is irreversible with a manual release
facility.
Optional accessories
SNAPPER4
PAF
PSR
SRS
SNR
FIX SNAP4
ADEK
STICKERS
LEDSNAPPER
CB24
SPB24
SUN POWER
H230T
30
Bar length
Circular section rigid bar, total length L4250 mm.
Fixed supporting foot.
Movable sporting foot.
Plastic skirt L2000 mm.
Articulated joint.
Fixing accessories.
Reflective adhesive for SNAPPER4 L4000 mm.
12 reflective stickers.
LED lights for SNAPPER4
24V battery charger, for use with 24V control unit.
Outdoor installation box with 2 12V 7Ah batteries.
Solar panel power supply kit suitable for installation on all 24 Vdc automation systems.
Heater to ensure gear motor operation even at low temperatures.
Power supply 230V power absorption 10W complete with thermostat.
3 m
MSNYELLOW
MSNGREEN
MSNGREEN
MSNGREEN
MSNGREEN
4 m
MSNYELLOW
MSNGREEN
MSNGREEN
MSNGREEN MSNRED
/
MSNRED
Publicidad
Tabla de contenido
