Assembly Instructions; Important - Urrea PP921A Manual De Usuario

5. FIXING KNOB WITH SQUARE NECK BLOT
6. LOWER HANDLE
7. GRASS BOX
8. FRONT DECORATIVE COVER
9. HEIGHT ADJUSTING HANDLE
10. REAR WHEEL
11. DECK
12. STARTER HANDLE
13. REAR DISCHARGE COVER
14. FRONT WHEEL

ASSEMBLY INSTRUCTIONS

ASSEMBLY
NOTE: This unit is shipped without gasoline or
oil in the engine. Fill up with gasoline and oil as
instructed in the accompanying engine manual
BEFORE operating your mower.
ASSEMBLING THE HANDLE
1. Fasten the lower handle to
The device by using two blots and
two small knobs on each side.
2. Unfold the upper handle and fix it to lower
handle
By using the big knobs and the blots on each
side
NOTE: Make sure the rope guide is on the right
handle, when you stand behind the mower.
TIDY THE CONNECTION CORD
Fix the connection cord to the handle
With the cord clip .(supplied)
ASSEMBLING THE GRASS BAG
Clip the plastic clips over the metal frame.
Make sure that these clips are fully secured to-
the metal frame.
ASSEMBLING THE GRASS BAG ONTO THE
MOWER
1. Lift the rear discharge cover with one hand
and hook in the grass bag.
2. Release the rear discharge cover to secure the
grass bag in position.
ASSEMBLING THE MULCHING PLUG
1. Remove the grass bag
2. Push the plastic mulching plug
Into the discharge chute
Until it is locked in place.
3. Then release the flap, it will close
Back to cover the mulching plug.
ASSEMBLING THE SIDE DISCHARGE CHUTE
NOTE: When use side discharge function.
E N G L I S H •
First need remove the grass bag and plug the
mulching plug.
1. Lift the side discharge cover with one hand
and hook in the side discharge duct with the
other hand.
2. Release the side discharge cover to secure the
duct in position.
ASSEMBLING THE CONTROL BOARD FOR
ELECTRIC START
1. Take out the plastic panel from the box.
2. Align the mounting holes on the plastic panel
with the mounting holes on the upper-handle.
3. Fix the plastic panel with the bolts and nuts
and provided.
4. Connect the engine cable and battery.
5. When charging the battery use the charge
socket for 3 hours before use.
CHECKING THE ENGINE OIL LEVEL AND FILL-
ING WITH ENGINE OIL.
DANGER: The following procedures and ad-
justments must be performed before the engine
is started.
Do not attempt to make any of these adjust-
ments while the engine is running.
DANGER: To prevent engine damage the
engine is shipped without oil or petrol. The en-
ginemust be filled with the correct grade of oil
and petrol before starting the engine.
IMPORTANT: Running the engine with a low
oil level will cause engine damage. It is recom-
mend that high detergent, premium quality
4-stroke engine oil used. Using non-detergent
oil can shorten the engine's service life and us-
ing 2- stroke oil will damage the engine.
DANGER: Always use high quality detergent
oil classified SAE30 oil (or equivalent e. g SAE
1 0W/30, often termed as 4 Stroke lawn mower
oil).
Never use additives with recommended oil.
To prolong the life of your engine it is important
that the oil is changed after the first 5 hours of
use.
IMPORTANT: To Check the engine oil level
,stop engine and place the mower on a level
surface.
1. Remove the oil filler dipstick and wipe oil
from it with a clean cloth.
2. lnsert the dipstick into the oil filler neck, but
do not turn it.
Us er 's M an u a l
15