Door Contact; Remote Controller - Blaupunkt SA 2900R Manual Del Usuario

3.7. Control Panel
The Control Panel tamper switch is located inside the mounting hole
1. Use the holes on the mounting plate, mark the position of the
holes on the wall at chest height.
2. Drill two holes into the wall, fix the mounting plate on the wall
with screw and plugs provided.
3. Hook the Control Panel onto the plate.
4. Adjust the Control Panel position on the plate to make sure the
tamper switch is fully depressed against the mounting plate.
3.8. PIR Sensor
When the IR-S4 detects a movement during arm mode, it will automatically trigger an alarm and notify
the user. The tamper protection is inside the device and is pushed down by the screw. If the device is
removed by an intruder, the tamper protection will trigger an alarm.
The IR-S4 needs to be mounted or glued to the wall with screws or adhesive tape. The best location
is in a corner to have wide motion detection range. Install the motion detector at 2m above the ground
for best performance.
Remove the back cover and push through the knockouts on the back (for example with a screwdriver)
where plastic is thinner. There are six knockouts on the back of the device that can be pushed though.
If you mount the device in a corner, push through the perforations on the side; if you mount the device on a plane surface, push through the perforations
in the center. Drill holes into the wall using the knockouts as template. Fix the IR-P4 base onto the wall with the screw and plugs provided. Place back
the back cover onto the IR-P4.
NOTE: The IR-S4 will go on sleep mode for 1 min. when detecting someone while alarm is deactivated. Please wait more than 1 minute without detecting
anyone to be sure the device its out of sleep mode before testing.

3.9. Door Contact:

The Door Contact DC-S4 monitors doors and windows in your home ensuring ideal protection.
The DC-S4 can be mounted with screws or with adhesive tape to the door or window frame. For a proper
operation we do not recommend to install the DC-S4 on steel doors/windows.
For screw installation, remove the back cover and push through the 2 knockouts on the back (for example
with a screwdriver) where plastic is thinner. Drill holes into the surface using the knockouts as template. Fix
the Door Contact base onto the surface with the screws and plugs provided. Place the back cover again
onto the Door Contact.
Make sure that the tamper protection is pressed down against the door/window surface, otherwise the
accessory will trigger a tamper alert.
The magnet should be installed adjacently at the sensor mark. Fix the magnet in the same way as the main
body of the door contact, either by screw installation or adhesive tape.

3.10. Remote Controller

With the Blaupunkt Remote Control RC-R3B you can easily change the status of the system between Arm, Disarm and Home mode.
Additionally the RC-R3B can be used to trigger a panic alarm by pressing the emergency button for
3s. The RC-R3B cannot disarm a panic alarm triggered by itself, it can be done via the App.
The RC-R3B works with rolling code encryption technology, for an improved security against
manipulation by third parties..
Note: For more information about the accessories included on the kit visit service.blaupunkt-
security.com for detailed user manual for each accessory.
The Q-Pro Series equipped with rolling code. A feature to encrypt and make the Security System
even more secure against so called replay attacks.
7
LED Indicator