Troubleshooting - DeLonghi EV250 Manual Del Usuario

- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit dif-
ferent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV techni-
cian for help.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user' s au-
thority to operate the equipment.

5. TROUBLESHOOTING

Below is a list of some of the possible malfunctions.
If the problemcannot be resolved as described, contact Customer Service.
PROBLEM
No discharge of air
The appliance switches off
Presence of water under the tank
Excessive humidity in the room
Odors and colored water
CAUSE
Cord is not plugged in
Power isnot ON
The auto shutoff timer was set
When the tank is completely extracted
without waiting a couple of minutes, the
residual water on the honeycomb cooling
pad will drip into the tank housing
In Cooler/Humidifying function, the ap-
pliance produces moisture as a result of
evaporative cooling. This is normal
When the appliance is new
Algae or mold due to moisture. In very
damp conditions, algae may form due to
moisture
•
This device complies with Part 15 of the FCC Rules. Ope-
ration is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
•
This Class B digital apparatus complies with Canadian
ICES-003.
SOLUTION
Make sure power cord is plugged in and the swi-
tchisON
Turn the unit ON by pressing the
( B1 on the control panel or D1 on the remote
control)
Turn the appliance ON and check that the auto
shutoff symbol is off
Dry the housing before re-inserting the tank. For
filling, follow the instructions in chap. 3.
The appliance cools best in dry climates. If the
ambient humidty level is high (60% or above) re-
frain from using the cooler/humidifying function
Make sure the window/doors are open and there
is adequate cross ventilation in the room so
that the air can circulate better. Utilize the "fan"
function
At first use, the appliance will have an odor,
which will dissipate within a few hours of initial
use. The color in the water will also dissipate after
afewuses.
Check the Honeycomb Cooling Pad (A12), water
tank (A7) and other cooler parts. If you see mold
spots or algae issue, use a damp cloth to wipe
away the algae until all spots have disappea-
red. Make sure all parts are clean and dry before
storage. Contact Customer Service if problem
persists. If the Honeycomb Cooling Pad (A11) has
algae or mold, change it with a new one
10
button