AMQ KINEX Guia De Instalacion página 12

PHASE 3 | Beam Assembly
(If there is power block option selected, recommend to install it
to beam first before assembling the beam to frame .) See Phase 6
for power block assembly .
2
Step 1
Adjust stretcher frame depending on the beam
length selected . Make sure the middle stretcher
bar is positioned right in the middle by using the
marking guides indicated on it .
Step 2
Slot beam into column bracket as in diagram
below .
Step 3
Screw in M10*22 screws to secure beam from the
front .
KINEX INSTALLATION GUIDE | 12
1
5
5
Step 4
Screw in M6*10 screws to secure the beam from
the sides .
Step 5
Tighten all 8 pre-installed socket screws to secure
the stretcher frame .
KINEX SINGLE RUN
3
amqsolutions.com
4