Selecting A Channel; Viewing The Information Banner And Channel Label (Digital Tv Only); Viewing The Program Guide (Digital Tv Only); Adjusting The Volume - Dynex DX-R24TV Guia Del Usuario

Using your TV
Warning: The AC plug supplied with this TV is polarized to help minimize the possibility of
3 Press the POWER
Note: You can set the TV to turn off automatically by setting the SLEEP timer. In TV mode, the

Selecting a channel

For information on channel numbering, see Understanding US channel numbering.
To select a channel:
• Press the CH – or CH + button on the remote control to go to the next lower or higher
channel.
Or
Press the number buttons to select a channel (for example, if you want channel 83,
press 8, then press 3).
Or
Press the

Viewing the information banner and channel label (digital TV only)

The information banner shows status information (such as the channel number and signal
source) on the screen. Additional information is available in digital TV mode.
To view the information banner and channel label:
• Press DISPLAY on the remote to show the information banner and channel label on
screen.
Or
Open the CHANNEL SETUP menu to view the channel label.

Viewing the program guide (digital TV only)

To view the program guide:
• Press GUIDE on the remote to show the program guide on screen.

Adjusting the volume

To adjust the volume:
• Press the VOL+ to increase the volume, or the VOL- button to decrease the volume.
• Press MUTE to mute the sound. Press MUTE again to restore the sound (you can also
restore the sound by pressing the VOL+ button).
electric shock. If the polarized AC cord does not fit into a non-polarized AC outlet, do not
file or cut the blade. It is your responsibility to have an electrician replace the obsolete
outlet. Do not use this plug with an extension cord or other outlet unless the blades can be
fully inserted.
button on the TV or the remote again to turn off the TV.
TV will turn off automatically, if there is no input signal for 15 minutes. After you turn off
the TV, you should wait at least 5 seconds before you turn it on again.
button to go to the last viewed channel.
17