3 . H OW D O ES M I (M U S C L E INTE LLIGENCE )
T E C H N O L OG Y W OR K ?
To access MI functions the MI-sensor cable (not available on all devices) must be connected to the stimulator.
MI-SCAN
Just before starting a work session, the MI-scan function probes the chosen muscle group and automatically
adjusts the stimulator settings to the excitability of this area of the body, depending on your physiology.
This function results in a short test sequence at the start of the programme, during which measurements
are taken.
At the end of the test, the intensity has to be increased to start the programme.
MI-TENS
The MI-tens function limits unwanted muscle contractions in painful areas.
With each intensity increase applied by the user, a test phase occurs, and if a muscular contraction is
detected, the device automatically reduces the intensity of the stimulation.
This function is only accessible in the TENS, Epicondylitis and Tendinitis programmes.
MI-RANGE
The MI-range function indicates the ideal range for adjusting stimulation intensity, to be followed in the
following programmes: recovery, massage, capillarisation or even muscle pain.
When the device has detected the ideal intensity range, check mark will appear on the screen. For optimum
work, intensity should be kept within this range.
Not all devices have MI technology. The table below shows which functions are available with each device.
MI-SCAN
MI-TENS
MI-RANGE
SP 2.0
SP 4.0
✓
✓
-
✓
-
✓
EN
FIT 1.0
FIT 3.0
✓
-
-
-
-
-
05