Operating Instructions; Heater Controls; Controlling The Humidity; Daily Use Instructions - DeVilbiss DV5HH Manual De Usuario

operATing insTruCTions/CleAning insTruCToins
Never touch the heater plate on the humidifier cradle. Never touch the heat transfer plate on the bottom of the water
chamber. these plates can reach temperatures as high as 149°F (65°c) during operation.
Do not operate the heater if the water chamber is empty. the heater plate may be turned off using the keypad heater
control when being used without water.

OPERATING INSTRUCTIONS

Heater controls

The heater controls and status are located on the keypad and display.
1. Heater Setting Control Buttons
2. Heater Power LED

controlling the Humidity

The heater setting can be adjusted in a range of 1 to 10. The optimum temperature setting is dependent on the ambient temperature and humidity of
your room. If your room temperature is low and/or the relative humidity is high, then a lower temperature setting may be necessary to prevent excess
condensation in the air supply tubing. If the room temperature is high and/or the relative humidity is low, then a higher temperature setting may be
necessary for optimum comfort.
The heater setting of 1 results in a heater plate temperature of approximately 84°F (29°C). The heater setting of 10 results in a heater plate
temperature of approximately 149°F (65°C).

Daily use Instructions

NOtE
– Always allow at least 10 minutes of cooling time after turning the device off before removing the water chamber from the humidifier cradle.
1. Press down on the chamber release latch of the humidifier and remove the chamber from the cradle (Fig 8).
2. Open the chamber and empty any water remaining from the previous night.
3. Clean the chamber according to the cleaning instructions and reassemble.

CLEANING INSTRUCTIONS

Water chamber

1. Press down on the chamber release latch and pull out the water chamber from the cradle (Fig 8).
2. Separate the chamber halves by pressing forward on the chamber disassembly lever and lifting the lid of the chamber (Fig 9).
3. Remove the sealing gasket from the chamber lid (Fig 10).
4. Wash the parts in a solution of warm water and mild dishwashing detergent.
cAutION– Hand wash only. Do not use any solutions that contain bleach, chlorine, alcohol, scented oils or other aromatic-based ingredients to clean the
humidifier components or tubing. These solutions may reduce the life of the product.
5. Allow the parts to dry before reassembly.
Reassembly
1. Insert the gasket seal into the groove on the chamber lid. Inspect the fitting of the gasket to ensure it is fully in place (Fig 11).
2. Snap the chamber base and lid together by inserting the tabs on the lid into the slots on the base.
EN
A-DV5HH 7