Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
KNOW
YOUR
TRIMMER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT.
Compare the illustrations with your unit to familiarize yourself with the location of the vadous controls
and adjustments. Save this manual for future reference.
Tube
Trimmer
Head
ON/STOP
Switch
Shield
/
Line Limiter
Blade
Starter Handle
Throttle
Trigger
Primer Bulb
Choke Lever
ON/STOP
SWITCH
The ON/STOP
switch
is used to stop the
engine. To stop the engine, push and release
the engine ON/STOP switch.
PRIMER
BULB
The PRIMER BULB removes air from the car-
buretor and fuel lines and fills them with fuel,
This allows you to start the engine with fewer
pulls on the starter rope. Activate the primer
bulb by pressing it and allowing it to return to
its original form.
CHOKE
The CHOKE helps to supply fuel to the engine
to aid in cold starling. Activate the choke by
moving the choke lever to the FULL CHOKE
position. After the engine attempts to start, move
the choke lever to the HALF CHOKE position.
Once engine has started, move the choke lever
to the OFF CHOKE position.
BEFORE
STARTING
ENGINE
WARNING:
Be sure to read the fuel
information
in the safety rules before you be-
gin. If you do not understand
the safety rules,
do
not
attempt
to fuel
your
unit.
Call
1-800-554-6723.
FUELING
ENGINE
_ WARNING:
Remove fuel cap slowly
when refueling.
This
engine
is
certified
to
operate
on
unleaded gasoline.
Before operation, gasoline
must be mixed with a good quality synthetic
2-eycle air-cooled engine oil designed
to be
mixed at a ratio of 40:1. Poulan/Weed
Eater
brand
synthetic
oil is recommended.
Mix
gasoline and oil at a ratio of 40:1. A40:1 ratio
is obtained by mixing 3.2 ounces (95 ml) ofoil
with 1gallon (4 liters) of unleaded gasoline.
DO NOT USE automotive
oil or boat oil.
These oils will cause engine damage. When
mixing
fuel, follow
instructions
printed
on
container.
Once oil is added
to gasoline,
shake container
momentarily
to assure that
the fuel is thoroughly mixed. Always read and
follow the safety rules relating to fuel before
fueling your unit.
IMPORTANT
Experience
indicates
that alcohol
blended
fuels
(called
gasohol
or using ethanol
or
methanol) can attract moisture which leads to
separation and formation of acids during stor-
age. Acidic gas can damage the fuel system
of an engine while in storage.
To avoid engine problems, empty the fuel sys-
tem before storage
for 30 days or longer.
Drain the gas tank, start the engine and let it
run until the fuel lines and carburetor
are
empty. Use fresh fuel next season.
Never use engine or carburetor cleaner prod-
ucts in the fuel tank or permanent
damage
may occur.
See the STORAGE
section for additional
in-
formation.
HOW TO STOP YOUR
UNIT
• To stop the engine, push and release the
engine ON/STOP
switch. The switch will
automatically
return
to the ON position.
Wait 5 seconds before attempting to restart
unit to allow switch to reset.
4
Publicidad
Tabla de contenido
