Putting Into Operation; Mounting The Cutting Disc - Makita DPC6410 Manual De Instrucciones Y De Seguridad

Para cortadora de muela de tronzar
Ocultar thumbs Ver también para DPC6410:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

STOP
A
1
B
5
7
C
10
2
D
2
3
4
Schematic drawing
7
5
8
9
8
1

PUTTING INTO OPERATION

CAUTION:
Always turn off the engine and pull off the spark plug cap
before doing any work on the Power Cut! Always wear
protective gloves!
CAUTION:
Start the Power Cut only after complete assembly and
inspection.
For the the following work, use the assembly tools included
with delivery:
1. 13/19 AF combination wrench
2. Allen key
3. Carburetor adjustment screwdriver
4. Adapter ring (not in the general delivery inventory)
Place the Power Cut on a stable surface and carry out the
following assembly steps:

Mounting the cutting disc

Inspect the disc for damage.
See SAFETY INSTRUCTIONS, Page 7.
Unscrew screw (9) and remove the spring washer (8).
Place the cutting disc (5) on the arbour (7).
Hinweis: The arbor hole of the cutting disc must be an exact
fit with the arbor or shaft. If the arbor hole is larger, it must be
fitted with an adapter ring (*).
Make sure the cutting disc is installed so it turns in the
right direction, if a direction is marked on the disc.
Place the spring washer (8) on the arbour and insert the screw
(C/9) and tighten by hand.
Turn the disc slowly until the stop hole of the V-belt pulley is
visible in the cutting arm cover (10).
Insert the Allen key (2) as far as it will go. The shaft is now
blocked.
Tighten the screw with the combination wrench (1)
NOTE: Tighten the screw firmly (30 ± 2 Nm), as otherwise
the cutting wheel may slip during cutting.
13

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Dpc6411Dpc7310Dpc7311

Tabla de contenido