Cutting Attachment In Central / Side Position; Repositioning The Cutting Attachment - Makita DPC6410 Manual De Instrucciones Y De Seguridad

Para cortadora de muela de tronzar
Ocultar thumbs Ver también para DPC6410:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Cutting attachment in
central / side position
NOTE: The Power Cut is delivered with the cutting attachment
mounted in the middle position (1). For cutting up against
obstacles, such as curbs or walls, the cutting attachment can
be mounted to one side (2). Use this position only when
actually necessary, and afterwards return the cutting attach-
ment to the middle position. In this position the Power Cut has
better balance, is easier to guide, and is not as fatiguing for the
operator.

Repositioning the cutting attachment

STOP
Loosen nuts (5).
Loosen the tightening screw (3) (counter-clockwise) until the
end of the screw (4) is visible in the gap.
Unscrew the nuts (5) and remove the cover (6).
Use the combination tool (8) to lever out the stop pin (7) as
shown in the illustration, until the protective hood (10) can be
turned.
NOTE: The turn stop (D/7) is deactivated when the stop pin (7)
is removed. This permits the hood (10) to be turned farther than
the turn stop (D/7).
Unscrew the grip (9) and turn the protective hood (10) as
shown in the illustration.
Disengage the V-belt (11) and remove the cutting attachment.
1
2
7
5
4
3
7
8
C
6
D
9
10
11
E
25

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Dpc6411Dpc7310Dpc7311

Tabla de contenido