Service; Maintenance; Hydraulic Oil - Husqvarna PP 325 E Manual De Instrucciones

Service

IMPORTANT! All types of repairs may only be carried
out by authorised repairmen. This is so that the
operators are not exposed to great risks.

Maintenance

IMPORTANT! Inspection and/or maintenance should be
carried out with the motor switched off and the plug
disconnected.
Cleaning
Make sure to keep the connectors and pins clean. Clean
with a rag or brush.
CAUTION! Do not use a high pressure washer to clean
the power pack. Do not wash the machine with water, as
water can enter the electrical system or the engine and
cause damage to the machine or short circuit.
12 – English
MAINTENANCE

Hydraulic oil

IMPORTANT! Changing liquids and filters must be done
in such a way that the machine's hydraulic system and
the surrounding environment are not damaged. Dispose
of residual products according to local laws.
The hydraulic oil should be replaced when needed or
once a year.
• Place a collecting vessel under the tank's drain plug
and open the plug.
• Screw on the drain plug when all the liquid has
drained out.
Hydraulic oil is refilled through the filter on the front of the
tank.
• Lay the power pack down with the filter housing facing
upwards.
• Remove the cover of the filter housing by removing
the three screws.
• Refill hydraulic oil through the filter element.
• Mount the filter housing cover.
• If also the oil filter is replaced, 12 l new hydraulic oil
should be filled.